Operation; Start-Up And Normal Operation; Operation On Battery Power; Low-Battery Warning - MGE Pulsar 700 Manuel D'installation Et D'utilisation

E N G L I S H
3.1

Start-Up and Normal Operation

i
For the initial start, AC power must be present to detect any wiring errors. Subsequently, the UPS can start even if AC
power is not present.
UPS personalization
If UPS personalization is desired, it is advised to enter the personalization mode at this time. This mode may be entered
using the buttons on the control panel or the Personal Solution-Pac software (Windows) included on the Solution-Pac CD-
ROM provided by MGE Office Protection Systems.
3.2

Operation on Battery Power

Transfer to battery power
Transfer to battery power

Low-battery warning

86-86700-00 A01
Press button (27) for approximately 1 second.
The connected devices are protected by the UPS.
◗ LED (20) is ON. If LED (22) is ON, a fault has
occurred (see the "Troubleshooting" section).
◗ During normal operation, the scroll button (25)
may be used to read UPS measurements (AC
input voltage, operating mode, battery capacity
and UPS serial number)
◗ The connected devices continue to be supplied by
the UPS when AC power is no longer available.
The necessary energy is provided by the battery.
◗ LEDs (20) and (21) go ON.
◗ The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
The display indicates the remaining backup time.
◗ LEDs (20) and (21) go ON.
◗ The audio alarm beeps every three seconds.
The remaining battery power is low. Shut down all
applications on the connected equipment because
automatic UPS shutdown is imminent.

Operation

Operation
3 — 1