Landxcape LX835 Guide D'installation page 5

Trees
Roots emerging from the ground should be avoided to prevent
damage.
Depressions and bumps
In case of large bumps (higher than 2cm) or dips (wider than
10cm and deeper than 2.5cm), please determine if the blades
TM
would touch the ground or if Landxcape would get stuck. If
this is the case, either make the inclines smoother or exclude
Max.10cm
TM
these areas from Landxcape 's operation.
Max.2cm
Max.2.5cm
Slopes
TM
Your Landxcape has the ability to safely climb slopes up to
35% (20°)*, so please avoid areas steeper than this.
35% (20°)
*How to calculate the slope of your lawn:
The slope would be:
35cm (Elevation)
=35% (slope)
35cm
100cm (Length)
Max. 35% slope
100cm
Length
Placement of boundary wire on slopes
The upper boundary wire should NOT be placed on slopes
steeper than 35% (20°), and it should be placed at a distance
of 26cm from any obstacle. The lower boundary wire should
NOT be placed on slopes steeper than 17% (10°), and it
should be placed at least 40cm away from any obstacle when
positioned on a slope that is 17%.
NOTE: The lower boundary wire cannot be laid across a slope
steeper than 17% as Landxcape will slip and cross outside
TM
the wire, especially when the grass is wet.
EN 5