Landxcape LX835 Guide D'installation page 12

Masquer les pouces Voir aussi pour LX835:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
Only for reference
LED light indicator on
the charging station
Light does not turn on
There is no power.
Boundary wire is connected successfully;
Green light on
Landxcape
The boundary wire isn't connected.
Red light on
Power supply is connected successfully, while
the wire is connected unsuccessfully.
Green light flashing
Landxcape
WARNING
• If your Landxcape
TM
is outside its territory, it will not move and "
Move it inside its territory and repeat Verification.
• If your Landxcape
is inside its territory but "
TM
• Your Landxcape
should always remain switched on. If you ever need to turn it off, then make sure you place it within its boundary area before you
TM
switching it back on again.
• Should your Landxcape
stop operating, simply restart it and operate it as you normally would.
TM
NOTE: Please refer to the Owner's Manual for more information.
Setting
Please refer to Owner's Manual "4.3 Setting".
12
Status
TM
is fully charged.
TM
is auto charging.
" is displayed, please refer to "Error Messages" in Owner's Manual for solutions.
4. Press
then
to send Landxcape
Landxcape
will follow the boundary wire to the charging station.
TM
5. Fine tune the outline shape of the boundary wire if necessary.
NOTE: If the boundary wire is broken during the testing or you need to
extend the boundary wire, please refer to "Joining the Boundary Wire"
in Owner's Manual for instructions.
Check the status of the LED light indicator on the charging station to make
sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by
pressing
then
.
If there is any problem during verification test, please refer to "Owner's
manual-Troubleshooting".
Confirm that the power cord is connected properly to the charger and that
the charger is connected to a suitable power supply.
/
Confirm that there are no breaks in the boundary wire.
Check that the boundary wire has been connected correctly to the
charging station.
Confirm that there are no breaks in the boundary wire.
/
" will be displayed.
back to the charging base.
TM
Action
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lx795Lx796

Table des Matières