Warranty Information - Kübler A40 Instructions D'utilisation

Manual
Draw-wire encoder A40 / A41
D5.2XXX.24XX, D5.350X.AXXX,
D5.55XX.XXXX
ENGLISH
(German is the original version)

1. Warranty information

• In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and the
operating reliability of the device.
• Your device has been quality controlled, tested and
is ready for use. Please observe all warnings and
information which are marked either directly on
the device or specified in this document.
• Warranty can only be claimed for components
supplied by Fritz Kübler GmbH. If the system is
used together with other products, there is no
warranty for the complete system.
• Repairs should be carried out only at our works.
For Questions please call +49 7720 3903-952.
2. Identification
Please check the particular type of unit and type
number from the identification plate. For further in-
formation please check our catalogue or visit our
website www.kuebler.com.
3. Installation
For mounting, the degree of protection specified
must be observed. If necessary, protect the unit
against environmental influences such as sprayed
water, dust, knocks, extreme temperatures.
The wire actuated transmitter is a high quality
measuring device and should be mounted to a flat
surface (see Fig. 1).
• Two M4 threads on the lower surface (max. screw-
in depth 8 mm) serve to fasten the encoder.
Fig 1: Mounting
• After fixing the wire-actuated encoder, check the
maximum extension length (see Fig. 2). Pull the
wire's end (wire insert, lock nut and setting nut)
piece or the wire to the indended fixing point.Do
not distort the wire!
Wire insert
Lock nut
Do not distort wire
when fixing!
Fig. 2: Extension length check
• Extend the wire up to the fixing point, ensuring it
is aligned and is not twisted. Tighten the lock nut
to fix the wire connector.
Attention! Do not extend the wire beyond the max.
allowable extension length and do not twist wire
insert.
Wire handling
Pull out the wire perpendicular to the wire outlet
(see Fig. 2)
Do not let the wire go; in every position and during
every move the wire must be stretched by the cable
drum's spring force.
For correct operation the wire must not be flat or
have any kinks.
Measuring range
max. extension length
Setting nut