Resetting The Unit - nVent RAYCHEM NGC-CMA Manuel D'installation

RESETTING THE UNIT

All resets should be performed without being connected to the
charger.
PERFORMING A SOFT-RESET
A Soft-Reset stops all running applications, but does not erase
any programs or saved data. Be sure to save any unsaved data
with a running application before performing a Soft-Reset.
– To perform a Soft-Reset press both reset buttons on
the keypad
– The Pocket PC restarts and displays the today screen
PERFORMING A HARD-RESET
A Hard Reset stops all running applications, but does not
erase any programs or saved data. Additional to a soft reset
all hardware registers will be erased.
– To perform a Hard-Reset press and hold down the F1 and F4
buttons
– While holding down these buttons, press the reset buttons
for about two seconds
– When the Pocket PC screen begins to fade, release the F1
and F4 buttons first and then release the reset buttons.
– The Pocket PC resets and powers on
Note: If you simultaneously push and hold the Reset, F1 and F4
buttons for more than two seconds, the battery disconnects. To
restart the device, either plug the device into the AC Adapter or
press the reset buttons again.
PERFORMING A CLEAN-RESET
A Clean Reset clears all user-installed settings, applications and
data from the device.
– To perform a Clean-Reset, press and hold F1, F3 and the
power buttons
– While holding down these buttons, press the reset buttons
for about two seconds
– When the Pocket PC restarts release first the F1, F3 and
power buttons first and then release the reset buttons
– The Pocket PC resets and powers on
nVent.com | 5