The Handle Installing; To Remove A Shelf; Wine Shelves; Legs/Feet - CASO DESIGN WineDuett 12 Mode D'emploi

 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
13.5.2

Legs/feet

Included in the delivery there are 3 bgger feet being pre-installed and one smaller foot, not
being fixed.
This small foot should be screwed into the hole in the hinge of the door.
By screwing or unscrewing this foot you can adjust the wine cooler to have an even stand.
13.5.3

The handle installing

The wine cooler comes with 1 metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
13.5.4

Wine shelves

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the wine shelves can be removed to accommodate larger bottles.
13.5.5

To remove a shelf

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
► Ensure that the tabs are firmly engaged in place before storing any bottles.
Please note
screw
27
handle