ONOFF PIJA Guide De Montage Et D'utilisation page 15

ADJUSTING THE RETURN SPEED
* Onoff PIJA dropper posts 150mm and 170mm only
Onoff PIJA dropper posts are all preset with the suitable air pressure
for optimal return speed, however air pressure check is required and
adjustment could be made from time to time. Please note that you will
need a high-pressure pump to perform the following operations.
IN CASE TO ADJUST THE AIR PRESSURE
WARNING
Recommended operating pressures is 230-250psi, DO NOT ex-
ceed 250psi.
PROTECTION CAP INSTALLATION
only when included
1
Run the cable
through the
protection cap.
OPERATION
To lower seat post: press and hold the lever, un-weight seat and then
push down or sit on the saddle to the desired height and then release
the lever immediately.
To raise seat post: Remove weight from saddle and press and hold the
lever until the desired height is achieved. Release the lever.
NOTES
If the seat post is lifted while in the lowered position, the inner tube
will extend from outer tube. This is normal and it will return to proper
position once weight is applied to saddle. Picking up the bike by the
saddle can also cause a temporary, spongy' feel.
1
Disassemble all of the clamps
from the top head of the post.
2
Use a compatible shock
pump and adjust to your
desired pressure.
2
Fix the cable stopper
to the pull rod.
3
Fix the protection
cap to the bottom of
the post.
EN
15