ONOFF PIJA Guide De Montage Et D'utilisation page 14

Run the cable through the rotary ferrules to the lever.
6
Put the nut into the lever with screw set at the left side of lever.
7
The nut should be positioned on the curve part of the center
blade.
Pull the cable until it is tight and fi x the screw with 2mm allen key.
8
2 mm
Push the lever for 5-10 times to eliminate possible cable loose.
9
Loosen the screw and pull the cable once again until it is tight, fi x the
10
screw with 2mm allen key.
Slide the cable into the guide under the lever, cut the cable in appro-
11
priate length and fi x the cable end.
Use 3mm hex allen key to fi x the clamp lever on the handlebar.
12
3 mm
14