Preparation - 3TECH RED L-200 Mode D'emploi

4. Mounting / Removing the Bur
4.1 Mounting the Bur
1) Insert and lightly turn the bur until it engages with the latch mechanism. (Fig.4.1)
2) Push the bur further inwards until it clicks into place.
CAUTION
– After the Bur is locked in place, lightly pull out the Bur to make sure the Bur is locked.
– If the Bur is not correctly secured it may release during operation and could cause injury.
– Do not use the handpiece if the bur is not correctly mounted, otherwise the chuck might be thrown
by the reactive force and the bearing might be damaged.
4.2 Removing the Bur
1) Push the push button with your thumb.
2) Pull out the bur.
20
5. Maintenance Method
After use, be sure to perform the maintenance below.
Push Button
This symbol on you product means that the product can be autoclavable up to Max. 135°C.

5.1 Preparation

Remove Contra Angle from the motor and detach the bur from the chuck.
Fig. 4.1
5.2 Cleaning
– Carefully clean all surfaces with a cloth impregnated with Spray.
– Wipe clean the Cellular Glass Optic Rod entry point and exit point
with an alcohol-immersed cotton swab. Remove all debris and oil.(Fig.5.1).
Push Button
Fig. 4.2
Cotton Swab
Glass Rod
Fig. 5.1
21