Dometic GROUP WAECO TC-21FL-ISO Notice D'emploi page 21

TC-21FL-ISO.book Seite 21 Mittwoch, 14. September 2011 9:43 09
TC-21FL-ISO
NOTE
I
The plug is safe against wrong polarity: You can plug it only in one
direction into the (fig. 3, page 2) socket.
➤ Connect the cooler
– Using the cable supplied to a 220-240 V socket, or
– Using the cable supplied to the 12/24 V socket in the vehicle (fig. 3,
page 2).
➤ Press the button "ON/OFF" at the control panel (fig. 2 A, page 2) to
switch on the cooling box.
✓ The cooling box starts to cool or heat the interior space.
Operating display
red (fig. 2 B, page 2)
blue (fig. 2 C, page 2)
7.3 Switch over between cooling and heating
➤ If you want to switch over between cooling and heating, press the button
"HOT/COLD" (fig. 2 D, page 2).
NOTE
I
The control unit of the cooling box has a memory function. It mem-
orises the selected temperature range for each mode (cooling and
heating). Thus the temperature range which is previously selected
in the mode is set again with each switching on or switching over.
✓ The red or blue operating display lights up and the device starts to cool/
heat.
➤ When you want to finish the cooling or heating process, press the button
"ON/OFF" (fig. 2 A, page 2).
➤ When you put the cooling box out of operation, disconnect it from the
mains.
EN
Operating mode
heating
cooling
Operation
21