Tiiwee TWPIR03 Mode D'emploi page 3

panel only fits properly in one orientation.
Install the bracket with the ball joint and slide the sensor in place. Your PIR
sensor is now ready to be installed on the mount.
General installation guidelines
Avoid positions near heat, direct sunlight or under rotating objects. The
mounting surface should be strong without any vibration. The sensor can
be mounted at a height between 2 and 4 meters. Please check the
function and adjust the angle of the sensor for maximum detection
sensitivity.
The included adaptor set (oval & circular) allows for an adjustment of the
detection angle and therefore of the observed area. Please choose the
respective adaptor and the recommended mounting position (vertical or
horizontal) depending on your personal needs.