Philips SC2001/01 Mode D'emploi page 24

EngliSh
24
Problem
I have switched on the
appliance but I cannot
increase or decrease the
light intensity.
The 'ready to flash' light
does not go on when I
place the appliance on
the skin.
The 'ready to flash' light
does not go on when
I place the removable
window on my skin, but
the cooling fan works.
4203.000.6357.3.indd 24
Possible cause Solution
The wall socket is Connect another appliance to the wall socket to check
not live. if the wall socket is live. If the socket is live but the
appliance still does not charge, contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre.
The adapter is not Make sure the adapter is inserted properly into the
inserted properly wall socket and/or the small plug is inserted properly
into the wall into the appliance socket.
socket and/or the
small plug is not
inserted properly
into the appliance
socket.
The appliance is Contact the Consumer Care Centre in your country,
broken. your Philips dealer or a Philips service centre.
The appliance has To reset the appliance, switch off the appliance and
to be reset. then switch it on again. If you still cannot adjust the
light intensity, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
You have not put Place the appliance perpendicularly onto the skin in
the removable such a way that all contact switches touch the skin.
window with Then check if the 'ready to flash' light is on and press
safety ring the flash button.
properly on the
skin.
If this does not work, place the appliance on a part
of your body where it is easy to establish full skin
contact, for example on your lower arm.Then check
if the 'ready to flash' light works. If the 'ready to flash'
light still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
The safety ring is Clean the safety ring carefully. If you are unable
dirty. to clean the safety ring properly, contact the
Consumer Care Centre in your country, your Philips
dealer or a Philips service centre to replace the
flash screen.
The overheat When the overheat protection has been activated,
protection has the fan still works. Do not switch off the appliance
been activated. and let it cool down for approx. 15 minutes before
you continue to use it. If the 'ready to flash' light still
does not go on when you place the appliance on
the skin, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
27-04-10 15:00