Frigidaire Gallery Série Instructions D'utilisation page 5

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
6.1.2. Support and lift up the door such as to clear the
lower hinge pin (Figure 6).
Figure 6
6.1.3. Remove the oven door from the appliance.
6.1.4. Gently lay the door on a work table handle up.
6.1.5. Reinstall the threaded pin at its initial position
(see A, Figure 7).
Figure 7
6.2 Oven frame modifications
6.2.1. Remove the six (6) screws and washers located
on the right side of the oven frame (see B, Figure
7). Keep the screws and washers to reinstall them
at step 6.2.5.
6.2.2. Remove the lower hinge on the left side of the
oven frame (See C, Figure 8) and install it on the
upper right side of the oven frame (see E, Figure
8).
6.2.3. Remove the upper hinge on the left side of the
oven frame (see D, Figure 8) and relocate it on
the lower right side of the oven frame (see F,
Figure 8).
(and Optional Electric or Gas Cooktop Combination)
Figure 8
6.2.4. Remove the threaded pin from left side lower
hinge (see G, Figure 9). Save the threaded pin for
reassembly later.
6.2.5. Replace the six (6) screws and washers removed
on step 1 on the left side of the oven frame (See
B, Figure 10).
6.3 Oven door modifications:
6.3.1. Remove the three (3) screws, each side, fixing
the outer door assembly (glass panel and
handle). Remove also the four (4) screws located
on top (2) and under (2) outer door assembly (see
H, Figure 11 (10 screws total)).
5
Figure 9
Figure 10
Figure 11