Frigidaire Gallery Série Instructions D'utilisation

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job
of installing easier. The first step of your installation should be to measure your current cutout
dimensions and compare them to the cutout dimensions chart below for your model. You may
find little or no cabinet work being necessary.
Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in
oven. These spacers center the oven in the space provided. The oven must be centered to prevent
excess heat buildup that may result in heat damage or fire.
Cutout openings
Do not install the
oven closer than the
dimension "I"
(see table) to any adjoining
cabinetry or walls on the door
hinge side. This will interfere
with oven rack removal.
NOTES:
1. Base must be capable of supporting 150 pounds (68 kg).
2. Allow at least 27¼" (69,2 cm) clearance in front of oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper installation of the built-in oven. If the oven decorative trim
does not butt against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is the
required depth.
4. For a cutout height greater than 28
each side of the opening under the appliance side rails. For a cutout height (H) greater than 28
you can order a larger bottom trim, contact a Service Center
A
27 (68,6)
F
Min.
24 / (63,2) 25¼ (64,1)
7
8
All dimensions are in inches (cm).
Printed in United States
(and Optional Electric or Gas Cooktop Combination)
QUALIFIED INSTALLER.
* Suggested distance from floor
is 31" (78,7 cm).
Minimum required distance is
4 ½" (11,4 cm).
Door Open
(see note 2)
/ " (71,4 cm) add one 2" (5 cm) wide wood shim of appropriate height to
1
8
PRODUCT DIMENSIONS
B
29 (73,7)
CUTOUT DIMENSIONS AND CABINET WIDTH
G (Min.)
Max.
24 (61,0)
Spacer
2" (5 cm) Wide Wood
Spacer if Needed
Figure 1
C
24 / (62,5)
5
8
H. Standard Height
(Others, see note 4)
Min.
27¼ (69,2)
English – pages 1-10, Español – páginas 11-19, Français -pages 20-28
1
United States and
Canada
Junction Box
/ " (72,7 cm)
5
8
D
24¾ (62,9)
I
Max.
28¼ (71,7) 4½ (11,4)
P/N 318206005 (16/05) Rev. B
Hole for
Cable
Electrical