Drive; Compressor (Accessory); Mortar Hose For Pneumatic Spray Lance; Mortar Hose For Automatic Spray Lance - Titan PowrPlast 600 Mode D'emploi

GB
overvIew
4.2

DRIVe

When an overload occurs, the mortar spraying machine
switches off automatically (red indicator light lights up).
Move selector switch (Fig. 3, 2) to "A" and disconnect mains
plug. Set delivery volume controller (Fig. 3, 1) to „ 0".
Wait around 5 minutes, then plug the mortar spraying machine
back in and switch on. Set the delivery volume required.
The drive unit heats up during operation. This
is normal and not a sign of malfunction.
4.3

cOMPReSSOR (AcceSSORy)

VkM 592 intake volume 590 l/min
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
36
4.4

MORtAR HOSe FOR PNeuMAtIc SPRAy LANce

1 Material connection mortar spraying machine
2 Atomizing air connection compressed air supply
3 Material connection spray lance
4 Mortar hose
5 Atomizing air connection spray lance
1
5 4
4.5

MORtAR HOSe FOR AutOMAtIc SPRAy LANce

1 Material connection mortar spraying machine
2 Control cable connection / controller
3 Atomizing air connection compressed air supply
4 Material connection spray lance
5 Mortar hose
6 Atomizing air connection spray lance
7 Control cable connection/ automatic spray lance
2
1
7 6
PowrPlast 600
2
3
3
5 4