Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
K
Wired - Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1.
In the Network Settings screen, change
Network type to Wired. Then, select Connect
and press the
OK
button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home theater to
your network wirelessly, select Change Network
at this point, change the Network type to
Wireless, and then go to the instructions for
wireless networks on this page.
Network Settings
Wired network connection failed.
MAC Address
IP Address
Subnet Mask
Gateway
DNS Server
Unable to connect to the network. Try the following: check if your IP address is set
correctly in IP Settings. Contact your Internet Service Provider for more information.
Change Network
IP Settings
2.
Use the
buttons to select IP Settings, and
then press the
OK
button. The IP Settings
screen appears.
3.
Select the IP Setting field, and then set it to
Enter manually.
4.
Select a parameter to enter (IP Address, for
example), and then press OK. Use the ,.
buttons on the remote control to enter the
numbers for the parameter. Or use the Num
keypad to enter a parameter number. Press and
hold the 123 button until the Num pad appears on
the screen. When the Num pad appears, select a
number using the ,.
the
OK
button. Use the
remote control to move from entry field to entry
field within a parameter. When done with one
parameter, press the
Press the , or . button to move to another
5.
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.
6.
Repeat Steps 4 and 5 until you have filled in all
parameters.
XX:XX:XX:XX:XX:XX
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
Retry
Close
button and then press
buttons on the
OK
button.
21
✎
You can get the network parameter values from
your Internet provider.
7.
When finished entering all the parameter values,
select OK, and then press the
home theater verifies the network connection
and then connects to the network.
Wireless Network
You can set up a wireless network connection in three
ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
Before you configure the wireless network
connection, disconnect any wireless network devices
currently connected to the product or, if applicable,
the product's current wired connection.
K
Wireless - Automatic
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 20:
1.
In the Network Settings screen, change
Network type to Wireless. The product
searches for and then displays a list of the
available networks.
Network Settings
Select your network type.
Network type
Wireless network
si-ap
iptime
KIMING_VTOWER
Refresh
WPS(PBC)
2.
Select the desired network, and then press the
OK
button.
3.
On the Security screen, enter your network's
security code or pass phrase.
Enter letters by selecting a letter with ,.
buttons, and then pressing
4.
When finished, select Done, and then press the
OK
button. The product verifies the network
connection and then connects to the network.
- English
OK
button. The
Wireless
You can connect your Blu-
ray player to the internet.
Please select which wireless
network to use.
OK
button.
Publicité
Chapitres
Table des Matières
