Samsung HT-H6500WM Manuel D'utilisation page 10

Connections
Installing the Speakers on the Tallboy Stands
* HT-H6530WM only - Front Speakers
1. Find the speaker cable that is attached to the Stand. Turn
the Stand and Stand Base upside-down, unravel the
speaker cable, and then draw it through the hole in the
Stand Base.
✎
Handle the Stand carefully. It is heavy.
2. Connect the Stand Base to the bottom of the Stand.
3. Insert three 5x20 screws into the marked holes in the
Stand Base, and then tighten them with a screwdriver as
shown in the illustration.
4. Place the speaker cable into the slot on the bottom of the
stand base.
5. Connect the assembled stand and a speaker together by
matching the labels on the stand and speaker with each
other as shown in the picture.
6. Insert a screw (5x20) into the hole on the rear of the
speaker and tighten by turning it clockwise with a
screwdriver.
7. Repeat steps 1 through 6 with the other speaker and
stand.
Speaker Cable Connections
1. Match each speaker cable bundle to the correct speaker by matching the color coded plug on each bundle
to the colored sticker on the bottom or back of each speaker.
2. Connect the speaker wire plugs from each speaker to the back of the product by matching the colors of
the speaker plugs to the colors of the speaker jacks.
In case of HT-H6500WM
Surround
Speaker (L)
Wireless Receiver Module
* Refer to page 6 for the speakers of HT-H6530WM.
* This product should be connected with the SWA-6000 only.
Front Speaker (R)
Subwoofer
Surround
Speaker (R)
10
1
3
5
Speaker
Stand
SPEAKERS OUT
FRONT FRONT
R L
SUBWOOFER CENTER
AUX IN FM ANT
SPEAKERS OUT
L
FRONT R FRONT L
SUBWOOFER CENTER OPTICAL
R
DIGITAL
HDM
AUDIO IN
- English
Stand Base
2
Stand
4
6
Front Speaker (L)
Center Speaker