Recycling Batteries; Battery Indicator; Cleaning; Maintenance - HALLINS NEWTON 50 Manuel D'utilisation

7.4 Recycling batteries

Lead batteries are classified as environmentally hazardous waste and therefore must
always be sent for recycling or destruction in order to avoid negative impacts on the
environment.

7.5 Battery indicator

The battery indicator shows a constant light when the batteries are charged, the indi-
cator shows the batteries' voltage in ten descending steps,
batteries are completely discharged, a column flashes in the red field. If technical faults
occur, contact technical service or the lifting trolley's supplier for troubleshooting.

8 CLEANING

As the lifting trolley contains electrical components, it is vital that cleaning is carried
out as recommended.
• Remove the load from the platform/lifting device before cleaning
WARNING! Never under any circumstances connect the lifting trolley to the mains
when cleaning.
Clean the lifting trolley by wiping the outside with a damp rag.
WARNING! Never rinse the lifting trolley with water at any time!

9 MAINTENANCE

In order for your lifting trolley to operate in the best possible way, it is important that
you perform regular maintenance as described below.
• Remove the load from the platform/lifting device before starting maintenance work.
• Inspections, service and repairs must be carried out by qualified personnel.
If you do not have your own technical competency, contact your lifting trolley
supplier for assistance.
Document any checks and repairs in a register, see chapter 10 Operation book • service
and maintenance.
Daily
1. Check that the charger is not connected to the lifting trolley
2. Check that the lifting trolley's control unit, charger and cable stand are not defective
3. Clean the lifting trolley according to cleaning instructions
22
see illustration 1. When the
Every month
1. Check all electrical connections and components and rectify any damage and wear.
Replace with new parts where necessary.
2. Check the chassis, mast and load bed as regards all types of defects, cracks, misalign-
ment, corrosion etc., and that all locking devices are in place and correctly attached.
3. Check that all wheels rotate freely and that the tyre rubber is intact. Lubricate the ball
bearings in the race.
4. Check that the wheel brakes are undamaged and work properly.
5. Check that the drive chain is undamaged.
6. Check that all stickers are legible and are in their right places.
7. Check that any strapping devices that may be used for the goods are intact and in
working order
8. Lubricate the inside of the mast with oil spray
10 OPERATION BOOK • SERVICE AND MAINTENANCE
Product service book:
Part number:
Serial number:
Delivered:
Service interval:
Example of content that must be completed during each service.
SERVICE & MAINTENANCE
Date:
Signature:
Observations:

11 TROUBLESHOOTING

The lifting trolley has been designed and tested to achieve optimal operational reliabi-
lity and service life, under the proviso that routine maintenance is carried out in accor-
dance with the specified instructions.
In the event of malfunction, always remove the load from the platform/lifting device
before carrying out troubleshooting and repairs. Inspections, service and repairs must
be carried out by qualified repairmen.
Symptom Procedure
Load bed does not move on signal
A. Check that control unit and charger are not defective
B. Connect the power cable to the mains and let it remain on charge for at least 8 hours.
If problems persist after you have taken these measures, you should contact an authori-
sed repairman or your supplier.
23