Electrical Connection - INVENTOR INVHM82A Manuel D'utilisateur

Installation
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Location
The appliance should be installed away from heat sources such as radiators, boilers, and direct sunlight.
Ensure that air can circulate freely around the back of the unit.
to leave 100mm of free space from the top of the appliance. Use the leveling feet, located at the
bottom of the appliance, to level the unit.
Warning! It must be possible to disconnect the appliance from the main power supply. Make sure the plug
is easily accessible after installation.

Electrical Connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your
domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a
contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a
separate earth in compliance with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Ambient temperature
Climate class
SN +10 C to +32 C
N
+16 C to +32 C
ST
+16 C to +38 C
T
+16 C to +43 C
10
o o
o o
o o
o o
For the best performance make sure