Tips; Troubleshooting - INVENTOR INVMS93A2 Manuel D'utilisateur

11. TIPS

Do not place products too close. Ensure a sufficient distance for optimum air circulation
✓
in the refrigerator.
Avoid extensive use of the door on wet and hot weather, keep in mind, once the door
✓
is opened to shut the soonest possible.
Do not place goods in direct contact with the wall of the refrigerator, always allow
✓
some space.
Never place inside the unit, hot or even warm goods without allowing them to chill first.
✓
Be certain the wall behind the appliance is dirt and dust free, especially with outer
✓
condenser equipped units.
Do not place goods that are not sealed or well packed directly under the chill box.
✓

12. TROUBLESHOOTING

ISSUE
Appliance is not
working
Lighting is not
operating
Temperature in
refrigerator is too
high or too low
Condensation
appears on the
outside surface of the
unit
Appliance is making a
noise
Odor
EN
CAUSE / REMMEDY
The plug is not in the socket. Put the plug in the socket.
Lamp defective. Replace the bulb as it is suggested on the
section "MAINTENANCE & CLEANING".
Thermostat has been set incorrectly. Set the thermostat
correctly.
This may be caused by a change in the room's
temperature. Use a soft cloth to wipe away any
condensation. If the problem remains, contact a certified
technician for assistance.
1) The refrigerant liquid causes noises in the cooling
system.
2) Noise is produced while the compressor is operating,
as refrigerant fluid is being pumped within the unit.
3) Make sure the refrigerator is levelled and balanced.
4) Goods have been placed incorrectly in the refrigerator.
Place the goods correctly in the refrigerator.
5) Check if the refrigerator's components are in the
proper position.
1) Goods are not stored in sealed containers
2) There are spoiled goods inside
3) The interior needs to be cleaned
15