LEXIBOOK BTP100 Série Mode D'emploi page 15

SNOOZE FUNCTION
When the alarm rings, press the SNOOZE button (8) to reset the alarm. Once the
snooze function is activated the alarm indicator will flash. And the alarm will sound
again after 9 minutes.
DIMMER FUNCTION
You can adjust the display brightness by pressing the DIM button (7) for high
brightness or low brightness.
ADJUSTING THE VOLUME
Press the volume up (10) or volume down button (6) to increase or decrease the
volume.
CAUTION : Too high volume, especially when using headphones, can damage
your hearing. For this reason, please turn the volume down.
USB MODE
When turning on the Bluetooth® speaker, the clock shows up in the screen by
default. To activate USB, Aux-in and Bluetooth® functions when the clock is on
screen, press the power button.
1. Once the device is on, first press the power button and then press the FUNC
button (5) repeatedly until "USb" appears.
2. Insert the USB into the USB port (14) on the back of the unit. The playback
will start from track 1 once the unit detects the USB. The display will show the
playing time.
3. Press button
press again to resume.
4. Press previous and next buttons during pause or playback to go back to the
previous track or listen to the next track.
Press and hold previous or next button to scan the playing track at high speed
until a desired point. The music will play from the chosen passage.
5. To stop the USB function, press the power button.
Note: In USB mode, the device takes approximately 4 seconds to detect the USB
drive in the USB port. If no USB drive is detected, "No" appears on the display.
During detection time, the FUNC button is deactivated. Therefore you will need to
wait until the end of the detection time to switch to another mode.
AUX-IN MODE
1. Once the device is on, first press the power button and then press the FUNC
button repeatedly until "AUX" appears. 2. Insert one end of the 3.5mm audio
cable (not included) into the Aux-in jack (16) and the other end to the jack of
your external audio player.
3. Adjust the volume of the main unit to your desired level.
4. Press PLAY on your audio player to start playback.
5. To stop the Aux-in function, press the power button.
Note : To get the best control experience of the music, use the on-screen track
controls of your music player for pausing, selecting next or previous track.
BTP100series_IM1246_V10_303.indd 15
to pause playback, the display screen will flash. Then
15
14/6/16 6:22 pm