Turning The Unit On And Off; Speaker Functions - LEXIBOOK BTP100 Série Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

First make sure the device is connected to power via the DC adaptor or that the

battery is fully charged if the adaptor is disconnected from the device.

1. To turn on the unit, slide the ON/OFF button (13) located at the rear of the

Bluetooth® speaker to "ON" position. The time will show on the display.

2. To unable the speaker functions, press the power button (1) on the top panel.

3. To switch it off, slide the ON/OFF button to "OFF" position.

WARNING : Significant electromagnetic interference or electrostatic discharges

may cause the device to malfunction or lose data. If the device is not functioning

correctly, switch it off and then on again, or unplug the adaptor.

TIME SETTING

Before the setting ensure the time will show on the display; otherwise press the

power button.

1. Turn on the device, press and hold the button

change the time setting.

2. Press previous or next button to select the time format (12H or 24H), then

press

3. The hour will flash on the display screen, press previous or next button to set the

hour, then press

4. After setting the hour, the minute will flash on the display screen. Press previous

or next button to set the minutes and press

time setting mode.

Note: In the 12H system, the PM indicator (23) lights up at noon to indicate the

time displayed is in the afternoon. And it turns off at midnight.

If you do not press any key during 4 seconds, the device will automatically exit the

time and alarm setting mode and display the clock on the screen.

ALARM SETTING

1. Press and hold the ALM button (9) to enter the alarm setting mode.

2. Press previous or next button to choose the desired alarm mode: BUZZ or USb,

then press ALM button to confirm the mode.

3. The hour will flash, press previous or next button to set the hour then press ALM

button to confirm.

4. After setting the hour, the minute will flash on the display screen. Press previous

or next button to set the minutes and press ALM button to confirm.

5. Once the alarm is set, the alarm indicator on the left corner of the display will

light up.

6. When the buzzer rings, press ALM or the power button to stop. And when the

music from the USB plays, press the power button to stop.

7. To cancel the alarm, press and hold the ALM button, then press previous or next

button to select "OFF" and confirm by pressing ALM button.

BTP100series_IM1246_V10_303.indd 14