LEXIBOOK Meteoclock Active Clock Revolution Mode D'emploi page 18

• Remove then re-install the filter (refer to image D).
2. Clean up the humidifier plate (the steam exit) located on the top of the water pump
by using a cotton pad.
3. Re-fill the water in the water tank.
4. If the above methods fail, install a new filter (refer to image D).
Note:
• The RL2000 is supplied with 5 new filters.
• When changing filter, fully insert the new filter inside the water pump (the filter must
touch the bottom of the tube).
• Do not press too hard on the top of the filter to avoid deformation.
In clock mode use the
1. In clock mode (time and date display), press and hold the SET key until the hour's
digits start flashing.
2. Use the and
and adjust the next setting.
3. The setting sequence is displayed in the following order:
Hours∞Minutes∞Year∞Month∞Day∞24hr/12hr display∞DM (Day/Month) or MD
(Month/Day) display∞DST function On/Off∞Day-of-week language.
Note:
• The day of the week can be displayed in 6 different languages: English (EN), French
(FRA), Italian (ITA), Spanish (ESP), German (DEU) or Portuguese (POR).
• When the DST function is turned on, the
4. Press the SET key to confirm your selection and go to the alarm setting.
Note: In time setting mode, if you do not press any key for 10 seconds, the unit will
automatically go back to clock mode.
18
TEMPERATURE DISPLAY IN °C OR °F
or keys to toggle between °C or °F temperature display.
CLOCK AND DATE SETTING
keys to increase or reduce the values, then press SET to confirm
icon is displayed in normal mode.