Getting Started - LEXIBOOK Meteoclock Active Clock Revolution Mode D'emploi

Humidifier
IMPORTANT: Use distilled water at room temperature to fill in the water tank.
1. Make sure the unit is turned off. If the main unit is connected to the humidifier,
remove it.
2. Pull up the water tank lid to remove it.
. Turn the water pump counter clockwise to unlock it, then pull it up.
4. Fill in the water tank with distilled water at room temperature.
5. Place back the water pump sideways and turn it clockwise to lock it. Place back the
water tank lid.
6. Plug the humidifier adapter (included) into any convenient AC 230V – 50Hz power
outlet.
7. Warning! When using the humidifier for the first time, after filling in the water tank,
wait for around 5 minutes before switching on the unit. Otherwise, the product may
not operate properly.
IMPORTANT NOTE:
• Only use the adapter supplied with the RL2000. Do not use other adapter.
• The socket-outlet shall be installed near the equipment and shall be easily
accessible.
WARNING: Mal-function or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, unplug the
AC/DC adapter from the mains socket and replug it again.
Main unit
1. Open the battery compartment located at the back of the main unit.
16

GETTING STARTED