Assembly; Add Engine Oil - Champion 100738 Mode D'emploi

Masquer les pouces Voir aussi pour 100738:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

100738 - 224cc ENGINE

ASSEMBLY

Add Engine Oil

DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the engine as a result of failing to follow these
instructions will void your warranty.
The recommended oil type for typical use is 5W-30
automotive oil. However, using the listed conventional oils
shown in the "Recommended Engine Oil Type" chart may be
used for typical use including the first 5 hours of the break-in
run time period of the engine.
If running engine in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
Recommended Engine Oil Type
5W-30
5W-30 Full Synthetic
°F
-20
0
20
°C
-28.9
-17.8
-6.7
Ambient temperature
1. Place the equipment on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 16.9 fl. oz (500 ml) (include) of oil
and replace oil fill cap/dipstick. DO NOT OVERFILL.
WARNING
NOTIcE
10W-30
10W-40
40
60
80
100
4.4
15.6
26.7
37.8
4. Check engine oil level daily and add as needed.
MAX
Once oil has been added, a visual check should show oil about
1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the
dipstick while checking.
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.
The engine is equipped with a low oil shut-off and will stop
when the oil level in the crankcase falls below the threshold
level.
120
48.9
The first 5 hours of run time are the break-in period for the
unit. During the break in period stay at or below 50% of the
running watt rating and vary the load occasionally to allow
stator windings to heat and cool. Adjusting the load will also
cause engine speed to vary slightly and help seat piston rings.
After the 5 hour break-in period, change the oil.
Synthetic oil may be used after the 5 hour initial break-in
period. Using synthetic oil does not decrease the recommended
oil change interval. Full synthetic 5W-30 oil will aid in starting
in cold ambient < 41º F (5º C) temperatures.
11
ASSEMBLY
OIL DIP STICK
NOTIcE
NOTIcE
cAUTION
NOTIcE
NOTIcE

Publicité

Table des Matières
loading

Table des Matières