Triton Unlimited Rebate Planer Instructions D'utilisation Et Consignes De Sécurité page 7

b. Working in the same order,
fully tighten all three screws
5. Loosen the vice and rotate
the drum to repeat the above
procedure to fit the other two
blades
REFITTING THE BLADE DRUM
1. Place the planer on its side
2. Raise the Drum Guard (17)
3. Slide the Blade Drum (16) onto the spindle and into the
housing
4. Press in the Drum Spindle Lock Button (26) and rotate
the Drum (16) until it is locked in place. Continue to
hold the lock button until you have secured the drum in
position
Note: the blade drum has two lock out positions
5. Re-insert the large washer, adjusting its position so
that it engages onto the end of the spindle
6. Insert the smaller washer followed by the hex head
screw
Warning: If the larger washer is not correctly
orientated the drum cannot be firmly secured.
7. Use the Hex Key (13) to fully tighten the hex head screw
to secure the drum in position
8. Release the spindle lock and close the drum guard
CORRECT SETTING OF BLADES
It is essential that the blades are set correctly or the
workpiece will end up rough and uneven. For a clean,
smooth cut, the blades must be mounted so that the
cutting edge is absolutely level. i.e. parallel to the surface
of the rear base (b)
(a)
Nicks in surface
The cutting edge of one or all blades is not parallel to the
rear base
Gouging at start
(a)
One or all blades are not protruding enough in relation to
the rear base
Gouging at end
One or all blades protrude too far in relation to the rear
base
(a)
2
1 3
(a)
(b)
(a)
(a)
(a)
(b)
(a)
(b)
(a)
(b)
(a)
(a)
(b)
(b)
FITTING THE SANDING DRUM
• A Triton Sanding Drum (24) and sanding sleeve are
supplied for use with this tool. You can convert the
Triton Unlimited Rebate Planer into a sander by fitting
the sanding drum in place of the blade drum
• Replacement sanding sleeves are available from your
Triton retailer (Part no. TRPSS)
• Using the sanding drum and sleeve, this tool is ideal for
quickly removing a large amount of material
• Do not use this sander for sanding steel or magnesium
Fitting a sanding sleeve
The sanding drum is supplied in two
sections. Separate the two sections
in order to fit or remove a sanding
sleeve
1. Ensure all the rubber 'O' rings are
in place
2. Slide the sanding sleeve fully
onto the larger section of the
sanding drum (Note: it will only
fit on one way)
3. Insert the smaller section of the
sanding drum into the sanding
sleeve and align so that the
groove in the inner ring of the
(b)
smaller drum section fits over
the nib on the spigot of the
larger section
Fitting the sanding drum in the
tool
• Always ensure that the tool is
switched off and unplugged
from the power supply
beforeinstalling or removing a
drum
(b)
• To fit or remove the sanding
drum, use the same method as
set out above for 'Removing the
(b)
Blade Drum' and 'Refitting the
Blade Drum'
PARALLEL FENCE GUIDE
1. Fit the Parallel Fence Guide (23) using the fixing angle
and the Parallel Fence Attachment Knob (22)
2. When set at right angles to the
planer base, the fence provides a
guide to help control the planing
(b)
action
(b)
GB
Preparation
7