KRONAsteel ANGELICA Série Guide De L'utilisateur page 11

EN Application sheet
INSTRUCTIONS ON THE USE
OF THE KITCHEN HOOD
The kitchen hood is to be used for extraction of
smells from the kitchen. It may work in two modes
depending on the method of its installation:
— mode of air removal into the air shaft;
— recirculation mode.
In the mode of air removal into the air shaft (see
Fig. 6), the kitchen hood is connected to the air
shaft with the help of a corrugated hose or a plas-
tic air conduit. Thus, all the evaporations from the
kitchen, smells, char and soot pas through reus-
able aluminum grease trap filters and are removed
outside the premises. With this working mode, it is
not necessary to install charcoal acrylic scent-trap
filters. Extraction mode is the most efficient as the
kitchen hood removes all the evaporations from
the kitchen to the air shaft.
In the recirculation mode (see Fig. 7), the kitch-
en hood is not connected to the air shaft, and thus
the air is just passed through the kitchen hood in-
side the kitchen.
In this mode, charcoal acrylic disposable scent-
trap filters should be installed on the kitchen hood.
These filters are not included in the set and are
bought separately. The use of the kitchen hood in
the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the
mode of air extraction to the air shaft.
MAINTENANCE AND SERVICE
OF THE KITCHEN HOOD
Before starting any cleaning or repair opera-
tion for the hood, turn off the mains voltage.
For external cleaning of painted hoods, use a damp
cloth moistened with warm water with a neutral de-
tergent. For top cleaning of steel, copper and brass
surfaces, use special tools, following the appropri-
ate instructions. Never use chlorine-containing
and acid-containing products, abrasive agents or
KITCHEN HOODS
sponges to clean the extractor, which can scratch
the surface.
Aluminum grease filter, retaining particles of fat
and passing through it the dust from the air, clogs.
It should be cleaned not with acid-containing sub-
stances or washed after preliminary soaking in hot
water with an effective detergent or, if possible, in a
dishwasher (at 65 ° C). Strongly soiled, grease filters
should not be washed in the dishwasher together
with the dishes. Simultaneously with the cleaning
of the grease collector, clean the fat deposits of all
available elements of the hood.
The process for removing the aluminum filter is
shown in Fig. 8; 9 . To remove the aluminum filter,
first open the hinged panel (item 3 on figure 1), and
then raise the spring lock knob on the filter and,
pulling yourself to remove the filter.
Do not install the filter in the hood until it dries
completely.
The filter is installed in reverse order. It is necessary
to press the spring lock on the filter and install it in
place, after which the lock is released.
For your hood, two coal filters are installed.
They are mounted on the protective grilles of the
motor duct by lightly pressing and turning them
clockwise. To remove the carbon filter, it should be
slightly squeezed and turned counter-clockwise
(Fig. 10).
To replace the backlight, it is necessary (see Fig.
11) to:
– disconnect the hood from the power supply and
find the burned out lamp wire;
– disconnect the power cable in the connector
by pressing the two lobes of the hood plafond,
removing the burned out lamp
– insert a new one into the place of the burned out
backlight;
– connect the lamp power lead in the connector;
– connect the hood to the mains and check the
operation of the backlight.
Installation of carbon filters
Replacing the backlight
9