INFOSEC UPS SYSTEM E4 LCD Pro 1000 Manuel Utilisateur page 31

cords.
For NEMA versions, we recommend the use of an AWG 12-10 or 3.3 mm
power cords.
A circuit breaker (40A) must also be installed between the mains and the AC input of the
UPS for the 3KVA NEMA models for safety operations.
c) Upon completion of the wiring connection, please check that the wires are securely
affixed.
d) Put the small cover back on the rear panel.
Step 3: Communication connection
Communication ports:
USB port
To allow for unattended UPS shutdown/start-up and status monitoring, connect one end of the
communication cable to the USB/RS-232 port and the other to the communication port of your
PC. With the monitoring software installed, you can schedule the UPS shutdown/start-up and
monitor the UPS status on your PC.
The UPS is equipped with an intelligent slot, ideal for either an SNMP or AS400 card. When
installing either an SNMP or AS400 card in the UPS, it will provide advanced communication
and monitoring options.
Note: A USB port and RS-232 port cannot work at the same time.
Step 4: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power up the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not
expect full battery run capability during this initial charge period.
Step 5: Install software
For optimal computer system protection, install the UPS monitoring software to fully configure
the UPS shutdown. Please follow the steps below to install monitoring software:
1. Insert the provided CD-ROM
2. Follow the on-screen instructions to install the software.
3. When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
Note: The UPS can be used without any communication connection: USB, SNMP or
RS232.
Step 6: External battery connection
For long-run models (S versions), before making external battery connection, please follow
chart below to connect external battery.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
31
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 08 14 AA XX 203 05
RS-232 port
2
Intelligent slot
2
-5.3 mm