Whakin WH0822 Guide D'installation Et D'utilisation page 7

Ensure that the flue outline is flat to the wall and level, avoiding trim strips etc.
If the flue needs to be mounted higher, the heater can be mounted on a board
to raise its height, as long as there is enough space to do so.
Drill four 6mm corner holes and cut aperture using flue template as a guide.
Reinforce the cut out with wooden batons (minimum 20mm wide).This may
require insulation in the wall to be removed.
Fig. 8 Reinforce flue hole
Step 3 Attaching the flue to the caravan
Apply sealant to seal the flue on the caravan side wall of the flue sealing face, ensuring each screw hole is
surrounded by sealant. Secure flue with the 6 screws (No. 8 x ") provided and remove excess sealant.
3 /4
Fig. 10 Attaching flue box
Step 4 Attaching the flue cover
Clip the top of the flue cover onto the flue box and secure with two screws (No.6 x ") provided once sealant has
1 /2
fully set.
Fig. 11 Installation and securing of flue cover
7