Rear - Sony LMD-440 Mode D'emploi

Rear

The illustration refers to LMD-440.
Each panel is equipped with connectors other than the DC IN jack and AC adaptor attachment.
1
A DC IN jack
Connect the supplied AC adaptor.
B AC adaptor attachment
Attach the supplied AC adaptor.
C VIDEO IN connector (BNC)
Connect to the video output connector of the VCR,
etc.
When input adaptor BKM-320D is connected to the
OPTION IN connector, this connector does not
function.
An optional input (OPTION) and video input
(VIDEO) can be switched by using the REMOTE
connector.
D VIDEO OUT connector (BNC)
Loop-through output of the VIDEO IN connector.
The connector is automatically terminated at 75 ohms.
E OPTION IN connector (D-sub 9 pin, female)
When optional Sony input adaptor BKM-320D is
connected, SDI signals are input.
NOTE
Do not install the other equipment than BKM-320D.
It causes to damage the unit or the equipment.
8
GB
Location and Function of Parts and Controls
2
3 45 6
F REMOTE connector (modular)
Forms a parallel switch and controls the monitor
externally. The pin assignment and factory setting
function assigned to each pin are given below.
1
Pin number Function
1 VIDEO IN
2 OPTION IN
(SDI)
3 Tally Red
4 Tally Green
5 Ground
6 N.C
7 N.C
8 16:9/4:3
Selectable
*Functions when BKM-320D is connected. When
both pins are shorted, OPTION IN (SDI) is prior to
VIDEO IN.
**LMD-720W only
LMD-530/440: N.C
To switch each function between high and low, change
pin connections in the following way.
High: Leave each pin open.
Low: Short each pin and 5-pin at the same time.
8
(High y Low)
(OFF y ON)*
(OFF y ON)*
(OFF y ON)
(OFF y ON)
(16:9 y 4:3)**