Tiiwee TWWS02 Mode D'emploi page 5

knife, remove the cover from the sensor by lifting the cover at the top of
the sensor. Then, position the sensor at the desired position. Now,
reposition the cover carefully on the sensor making sure not to damage
the clips.
• Installation with double sided tape: Peel off the protective foil from one
side of the tape and stick the tape onto the sensor. Then, peel off the
other part of protective foil and stick the sensor onto the door or
doorpost.
Test your door sensor
1. After the installation, open the window or door.
2. The red indicator light on the front of the sensor will flash once.
3. The sensor is now properly setup.
Low battery indicator
If the red control light on the sensor flashes every 3 seconds the battery needs to
be replaced.
Replacing the Battery
•
Place a screwdriver or knife in the opening at the bottom and use it as a
lever to lift the case from the back plate.
•
Take out the old battery and replace it with a fresh 12V/23A alkaline
battery - please note the correct polarity
•
Put the battery cover back in place and push it until you hear a click
Copyright © 2019 Tiiwee. All rights reserved. This manual or any portion thereof may not be reproduced or used in any manner whatsoever.