Tiiwee TWWS02 Mode D'emploi page 4

Image 1: Door and doorpost are at the same level. Sensor and magnet are
positioned next to each other and the triangle markers are aligned.
Image 2: The door or doorpost are at uneven levels with the door
protruding relative to the doorpost. Mount the magnet sideways on the
top of the door and position the sensor with a few millimetres distance on
the doorpost aligning the triangle markers on the sides of the sensor and
magnet.
Image 3: The door or doorpost are at uneven levels with the doorpost
protruding relative to the door. Mount the sensor sideways to the
doorpost and then position the magnet on the door with a few millimetres
distance aligning the triangle markers on the sides of the sensor and
magnet.
Installation
• Make sure that both the installation surfaces are clean and free from
grease and dust.
Magnet:
• Installation with screws: Using a small screwdriver or the tip of a small
knife, remove the cover from the magnet by lifting the cover at the top
of the magnet. Then, position the magnet at the desired position. Now,
reposition the cover carefully on the magnet making sure not to damage
the small clips.
• Installation with double sided tape: peel off the protective foil from one
side and stick the tape onto the magnet. Then, peel off the other part of
protective foil and stick the magnet onto the door or doorpost.
Sensor:
Before installing the sensor, please assure that both the magnet and
sensor will be aligned as described above.
• Installation with screws: Using a small screwdriver or the tip of a small
Copyright © 2019 Tiiwee. All rights reserved. This manual or any portion thereof may not be reproduced or used in any manner whatsoever.