How To Use Your Dryer - Indesit G74V Mode D'emploi

Where to put and vent your dryer
Permanent
In conjunction with the vent hose we recommend the use of a
Venting
Wall/Window Vent Kit. These are available from your retailer or
nearest Spares Centre.
Wall/Window
Fitting instructions are supplied with the kits, which can be mounted
Venting
through a wall or window. Details of positioning for wall mounting
are as follows:- Break a hole through the wall to the left of the
proposed position for the dryer. Keep the hose as short and straight
as possible to prevent condensed moisture running back into the
dryer. Similarly the duct inser ted into the wall should slope
downwards to the outside. For window venting with stacked dryer,
the hole in the window should ideally be made below the outlet and
the hose should be kept as short as possible.
A
Depending on the frequency of use, it is essential that the areas
B
A and B in the illustrations are checked periodically and any fluff
or debris removed.
It is particularly important that the vent hose adaptor is fitted
securely thus preventing any moisture laden air from being
emitted back into the room.
NOTE: The dryer should not be pushed so far back that the
hose adaptor is pulled out of position or the hose squashed.
Storm cover
The hose should be kept clear of the air intake grille and kinks
or 'U' bends avoided as these will obstruct the hose or trap
condensation.
WARNING:
1. ENSURE THAT THE DRYER IS ADEQUATELY
VENTILATED AND THAT THE END OF THE VENT HOSE
IS NOT DIRECTED TOWARDS THE AIR INTAKE DUCT.
2. THE DRYER MUST NOT RECYCLE EXHAUST AIR.
3. THE VENT HOSE MUST ALWAYS BE FITTED FOR
OPTIMUM PERFORMANCE.
4. MAKE SURE THAT THE VENT HOSE AND AIR INTAKE
GRILLES ARE NOT OBSTRUCTED OR BLOCKED.
5. MISUSE OF A TUMBLE DRYER MAY CREATE A FIRE
HAZARD.
6. DO NOT DISCHARGE THE EXHAUST AIR INTO A FLUE
WHICH IS USED FOR EXHAUSTING FUMES FROM
OTHER APPLIANCES BURNING GAS OR OTHER FUELS.
For open window venting it must be possible for the end of the hose
to be directed downwards to prevent warm, moist air condensing in
the room or in the dryer.
4

How to use your dryer

1. Plug in, switch
WARNING: WHEN
on electricity.
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY
3. Open the door.
Check that the fluff
filter is clean. Lift
filter upwards, clean
away any fluff,
replace filter
correctly.
5. Select the relevant
Button Out
heat setting (see
LOW HEAT
section "Sorting your
laundry").
Button In
HIGH HEAT
7. When finished,
open the door and
take out the laundry.
Clean and replace
the fluff filter.
2. Sort your laundry
(see section "Sorting
Your Laundry")
4. Load the dryer,
placing the clothes
carefully in the drum
pushing them well
towards the back and
away from the door
seal. Close the door.
6. Select drying time
required. The
machine will start.
8. Switch off electricity
and remove plug from
WARNING: WHEN
socket.
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY