Problem Solution; Environmental Protection - Worx WA3743 Mode D'emploi

center. If the new battery pack displays the same problem
as the original Battery Pack, have the charger tested at an
authorized service center.
Light ON/flash
Red on
Red flash
- - - - -
Green on
Green flash
- - - - - -

PROBLEM SOLUTION

1. I CANNOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
1) Check if the charger and the battery pack are specifically
designed for working together.
2) The battery can be inserted into the charger only in
one direction. Turn the battery around until it can be
inserted into the slot, the indicator light should be
green and flash when the battery is charging.
Status
Defective Battery
Battery Temperature
Protection
The temperature of
battery pack is less than
0 C or more than 45 C.
o o
Fully Charged
Charging
2. REASONS FOR DIFFERENT CHARGING TIMES
The charging time can be affected by many reasons
which are not defects in your product.
1) If the battery pack is only partly discharged it may be
re-charged in less than rated charging time.
2) If the battery pack and ambient temperature are very
cold then re-charging may take more hours.
3) If the battery pack is very hot you must remove your
battery pack from the charger and allow your battery
pack to cool first to ambient temperature and then
recharging can be started.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your tool requires no additional maintenance. Never use
water or chemical cleaners to clean your tool. Wipe clean
with a dry cloth. Always store your tool in a dry place.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
7