Philips Jamie Oliver HR1055 Mode D'emploi page 8

EnglisH
8
The slicing and shredding discs are intended for slicing and shredding vegetables like cucumber,
carrots, potatoes, leeks and onions and certain kind of cheese. The Julienne disc is intended for
cutting vegetables into thin sticks.
Never process hard ingredients like ice cubes with the appliance.
The cutting edges are very sharp. Do not touch them.
7 Place the disc holder on the tool holder (Fig. 4).
8 Put the lid with feeding tube on the bowl with spout (1). Turn the lid clockwise (2) to fix
it (Fig. 5).
9 Put the mains plug in the wall socket (Fig. 6).
using the appliances
The slicing and shredding discs are intended for slicing or shredding vegetables like cucumber,
carrots, potatoes, leeks and onions and certain kinds of cheese.
The julienne disc is intended for cutting vegetables into thin sticks.
Never process hard ingredients like ice cubes with the appliance.
The cutting edges are very sharp. Do not touch them.
1 Put the ingredients in the feeding tube. (Fig. 7)
- Pre-cut large ingredients into pieces that fit in the feeding tube.
- Fill the feeding tube evenly for the best results.
- To shred cheese, e.g. Parmesan, Gouda or Emmentaler, the cheese should be at refrigerator
temperature.
Note: Certain ingredients may cause discolouration. If you spill ingredients on the outside of the Cutting
Tower, wipe away the spills immediately.
2 Put the pusher onto the ingredients in the feeding tube (Fig. 8).
3 Turn the control knob to speed 1 or 2 and push down the pusher. (Fig. 9)
Use speed 1 for soft ingredients like mushrooms. Use speed 2 for hard ingredients like carrots.
Discs and their use (Fig. 10)
cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Switch off and unplug the appliance.
2 Turn the lid with feeding tube anticlockwise to remove it from the bowl with spout.
3 Lift the disc holder and the tool holder out of the bowl with spout.
4 Remove the disc from the disc holder.
5 Turn the bowl with spout anticlockwise to remove it from the motor unit.
6 Clean the bowl with spout, the lid with feeding tube, the pusher, the tool holder, the disc
holder and the discs with warm water and some washing-up liquid or in the
dishwasher. (Fig. 11)
Clean the discs very carefully. The cutting edges are very sharp.
7 Wipe the motor unit with a moist cloth. (Fig. 12)