Main Specifications - Tanita Step PD-642 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Usage 7. Battery replacement

The display fades as the battery runs down. Replace the LR44 battery promptly.

Remove the back cover

Use a small Philips screwdriver to remove the 4 case screws

from the back of the case, then remove the inner ring and the

back cover.

* Handle the screwdriver and any other tools with care.

Remove the battery contact plate

Remove the two screws fastening the battery contact plate,

then remove the contact plate.

Replace the battery

Take out the old battery and insert a new one (LR44).

Fasten the contact plate back in its original position

Put the contact plate back in its original position and screw it

securely into place.

Attach the back cover

Fit the inner ring into the groove in the body so that it does

not slip out of position, then fit the cover from above. Finally,

fasten the cover securely with the four case screws.

Notice

•

If you replace the battery yourself, your guarantee may not

cover splash resistance, due to misplacement of components,

etc. Check the procedures and positions of components, etc. thoroughly.

•

Always reset the system after removing or replacing the battery.