Gotec RAPIDO Notice D'utilisation page 6

The condensate removal pump is integrated in an elbow of duct to be installed directly on the outlet side of the air-
conditioner. From its dimensions, it is adaptable to practically all models of duct. The
ceiling-mounted and wall-mounted air conditioning units.
1. CHARACTERISTICS :
- Maximum flow rate :
- Maximum discharge :
- Voltage :
- Power :
- Alarm contact :
2. CONNECTION :
2.1 Electric power connection :
The pump is delivered wired with a 6 lead cable. Brown &
blue leads are for the two phases of the 230V supply, and the
green/yellow lead has to be connected to earth. The red,
black and white leads are for alarm; see below. The electrical
installation shall be done by a competent and approved
installer in respect of local regulations. At the free extremity of
the cable, provide an electric protection and isolating device
(not supplied) conforming to the IEC 345 standard on phase
and neutral. Warning : before connecting the power supply,
ensure that the cover of the pump unit is properly closed.
Gotec SA, Rue des Casernes 59, CH-1950 Sion
Condensate removal pump
8 l/h
6m CE
230V / 50Hz
18 VA
NO / NC maximum voltage 230VAC/VDC, max. switching current 8A admissible at resistive
load.
RAPIDO
E-Mail : info@gotec.ch
6
RAPIDO is suitable for mini-split,
Tél. (027) 205 7 205 - Fax (027) 205 7 206