VISIOMED BIOSYNEX EXACTO ThermoFlash premium Manuel D'utilisation page 23

declarations
13.1 Electromagnetic Emissions – For all EQUIPMENT and SYSTEMS
Guidance and manufacture's declaration – electromagnetic emission
The [EQUIPMENT or SYSTEM] is intended for use in the electromagnetic environment specified
below. The customer of the user of the [EQUIPMENT or SYSTEM] should assure that it is used in
such an environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-3-2
oltage f luctuations/ f
emissions
IEC 61000-3-3
13.2 Electromagnetic Immunity – For all EQUIPMENT and SYSTEMS
The [EQUIPMENT or SYSTEM] is intended for use in the electromagnetic environment specified
below. The customer or the user of [EQUIPMENT or SYSTEM] should assure that it is used in such
an environment.
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical f
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage di ps, short
interruptions a
voltage v
on pow er s upply
input lines
IEC 61000-4-11
24
licker
Guidance and manufacture's declaration – electromagnetic immunity
IEC 60601 test
Immunity test
level
±8 kV contact
±15 kV air
ast ±2 kV for power supply
lines
±1 k V f or i nput/output
lines
±1 k V di
mode. ±2 k V c ommon
mode
<5% UT
nd (>95% dip in UT)
ariations for 0.5 cycle
40% UT
(60% dip in UT)
for 5 cycles
70% UT
(30% dip in UT)
for 25 cycles
<5% UT
(>95% dip in UT)
for 5 sec
Compliance
The [ EQUIPMENT o r S YSTEM] u se R F
energy onl y f or i ts i nternal f unction.
Therefore, i ts R F e missions ar e v ery l ow
Group 1
and
interference
equipment.
Class B
Not applicable
Not applicable
Compliance
level
±8 kV contact
±15 kV air
Not applicable
fferential Not applicable
Not applicable
Electromagnetic environment –
guidance
are not likely
in nearby
Electromagnetic
environment -
guidance
Floors should be wood,
concrete or
ceramic tile. If floors are
covered
with synthetic material, the
relative
humidity should be at least
30 %.
to cause any
electronic