HP OfficeJet Pro 8500 Guide De Démarrage page 11

Masquer les pouces Voir aussi pour OfficeJet Pro 8500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The HP Officejet/Officejet Pro
device can send faxes
but cannot receive faxes
The HP Officejet/Officejet Pro
device cannot send faxes but
can receive faxes
The display always shows
Phone Off Hook
The HP Officejet/Officejet Pro
device is having problems
sending a manual fax
Fax tones are recorded on my
answering machine
If you are not using a distinctive ring service, check to make sure that the
on the HP Officejet/Officejet Pro device is set to
Off
If Auto Answer is set to
, or you have a voice mail service at the same phone number you use
for fax calls, you can only receive faxes manually.
If you have a computer dial-up modem on the same phone line with the HP Officejet/Officejet
Pro device, check to make sure that the software that came with your modem is not set to receive
faxes automatically.
If you have an answering machine on the same phone line with the HP Officejet/Officejet Pro
device:
Check that the answering machine is working properly.
Make sure the HP Officejet/Officejet Pro device is set to receive faxes automatically.
Rings to Answer
Make sure the
answering machine.
Disconnect the answering machine and then try receiving a fax.
Record a message that is approximately 10 seconds in duration. Speak slowly and at a low
volume when recording your message. Leave at least 5 seconds of silence at the end of the
voice message.
Other equipment that uses the same phone line might be causing the test to fail. You can
disconnect all the other devices and run the test again. If the Dial Tone Detection Test passes,
then one or more of the other equipment is causing problems. Try adding them back one at
a time and rerunning the test each time until you identify which piece of equipment is causing the
problem.
The HP Officejet/Officejet Pro device might be dialing too fast or too soon. For example, if you
need to access an outside line by dialing "9," try inserting pauses as follows: 9-XXX-XXXX (where
XXX-XXXX is the fax number you are sending to). To enter a pause press
Symbols
*@
the
or
button repeatedly, until a dash (-) appears on the display.
You are using the wrong phone cord. See the first two issues under "The HP Officejet/Officejet
Pro device is having problems sending and receiving faxes" on page 10.
This possible solution applies only in the countries/regions that receive a 2-wire phone cord
in the box with the HP Officejet/Officejet Pro device, including: Argentina, Australia, Brazil,
Canada, Chile, China, Colombia, Greece, India, Indonesia, Ireland, Japan, Korea, Latin
America, Malaysia, Mexico, Philippines, Poland, Portugal, Russia, Saudi Arabia, Singapore,
Spain, Taiwan, Thailand, USA, Venezuela, and Vietnam.
If you are sending a fax manually from your phone that is connected directly to the HP Officejet/
Officejet Pro device, you must use the keypad on the telephone to send the fax.
See the information about answering machine - related problems for the "The HP Officejet/
Officejet Pro device can send faxes but cannot receive faxes" topic in this table.
All Rings
.
setting is set to a greater number of rings than the
Distinctive Ring
feature
Redial/Pause
, or press
Solve fax problems
11

Publicité

Table des Matières
loading

Table des Matières