Preset Parameters - Izzo VIVI PID PLUS Manuel D'utilisation Et De Maintenance

To deactivate the boiler resistor press the key
the display shows OFF.
To activate coffee boiler resistor, simply press the key
Press the key
shows Prg press the key
Once the temperature setpoint has been displayed, use the keys
to set the desired value, from a minimum of 121°C to a maximum of
128°C. 3 seconds after pressing the last key the data is memorised and the
display shows the temperature.
With the machine of, press the keys
keeping them pressed turns the machine on. When the display shows F.03,
release the keys.
The key
parameter. To quit programming, turn the machine off and then on again.
N.B. It is recommend to use the default parameters set by the
manufacturer (see Par. 5.4).

5.3 PRESET PARAMETERS

To perform the PRESET, with the machine off press the key
machine.
When the display shows PrS, release the key and turn the machine off and
then on again. Reset all values as per the "Default Parameters" table (Par.
5.4), for the desired temperature refer to the "temperature range" table.
It is possible to reconfigure the Display with default parameters (factory
settings) using the PRESET operation.
To perform the PRESET, with the machine off press the key
machine. When the display shows PrS, release the key and turn the machine
off and then on again.
to program the temperature setpoint, when the display
.
scrolls the parameters while the key
for about 2 seconds and
.
and at the same time and
confirms the selected
and
and turn on the
and turn on the
9