DWT DS-150 KS Notice Originale page 17

• Clean all the parts by the soft brush and mount on
spindle 14: flange 15, gasket 16, grinding disc 3, gas-
ket 16, and flange 15� Attention: mount flanges 15
exactly as shown on fig. 4, do not turn them.
• Holding grinding disc 3 with one hand, screw nut 17�
• Install protective housing 4 and cover 2�
• Fix the position of cover 2 with the help of fasten-
ers 13�
Initial operation
of the power tools
Always use the correct supply voltage: the power sup-
ply voltage must match the information quoted on the
power tool identification plate.
Switching the power
tool on / off
Switching on:
Move switch 8 into the "On" position�
Switching off:
Move switch 8 into the "Off" position�
Recommendations
on the power tool operation
Select the type and grain structure of
grinding disc 3 depending on the ma-
chined material and the roughness of the
surface that you are expecting to achieve.
• Put the power tool on the work table, it is desirable
to fix it with the use of bolts or clamps.
• Lower protective glass 1 as down as possible to
grinding disc 3�
• Start the power tool, wait until grinding disc 3 has
reached its maximum rotation speed and smoothly
move the workpiece placed on supporting plate 5 to
grinding disc 3�
• Do not apply excessive pressure to the workpiece,
as it will not bring better results but it will overload the
engine and wear, the workpiece will be heated and
grinding disc 3 will be worn out more quickly�
The manufacturer reserves the possibility to introduce changes. The manufacturer reserves the possibility to introduce changes.
• Move the workpiece to the left / the right a little bit� It
will ensure even wear of grinding disc 3�
• It is recommended to place the workpiece in the wa-
ter from time to time in order to avoid its overheating
during treatment�
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
17
Transportation
of the power tools
Environmental
protection