System Overview - ILLUMINOSS SY-2000 Instructions D'utilisation

5. System Overview

The Light Source Console is a special purpose light source for the curing of Photodynamic Monomer in the
IlluminOss Medical Inc Photodynamic Bone Stabilization System. It emits a specific spectral output from the
Light Guide to effect curing.
The unit consists of aluminum housing containing a 75W power module, lamp and lamp mount, an internal
UV light band pass filter, a shutter system, and a programmable timer control board with a timer key inter-
face. The shutter is supplied with "Foot Pedal Enabled" and "System Standby" operation modes. The Light
Guide plugs into the Light Guide Mount.
The power supply operates on universal line voltages from 100-240VAC, 50-60Hz and is an auto-ranging
power supply specially designed to provide properly rated voltage and current to the 75W lamp.
A cooling fan with a control loop is provided to keep the lamp housing and internal components of the
power supply at the optimum operating temperature. The fan must not be covered or otherwise blocked. The
light source is a 75W, medium pressure arc metal halide lamp mounted in a reflector and focused to provide
optimum light output. The console is rated for continuous operation.
The bulbs used to power the system all degrade with repeated use. Intensity, therefore, decreases as the bulb
ages. A "Change Bulb" light illuminates when bulb replacement is required.
FRONT PANEL
LIGHT G UIDE M OUNT
SHROUD & K EY S LOT
THIS END TO LIGHT SOURCE CONSOLE
900093.S PHOTODYNAMIC LIGHT CURING SYSTEM INSTRUCTIONS FOR USE - ILLUMINOSS MEDICAL INC
SYSTEM S TANDBY
POWER S WITCH
Light Guide
BACK PANEL
FOOT PEDAL MOUNT
EQUIPOTENTIAL
FAN COVER AND FIL TER
GROUND PLUG
FUSE
POWER PLUG MOUNT
THIS END TO LIGHT PIPE
PAGE 5 OF 96
.