Using The Appliance; Cleaning And Maintenance - ECG ZH 1321 Mode D'emploi

BEARD TRIMMER
Warning: The red LED is on even after the device is fully charged.
The operating time with a fully charged battery is about 30-35 minutes.

USING THE APPLIANCE

NOTES:
The trimmed beard must be dry.
to the cutting angle.
and then use shorter cut lengths gradually during cutting.
device by sliding the switch to the ON position.
time, turn on the trimmer by sliding the switch to the ON position and make
sure that the appliance works normally and the blades move smoothly.
Setting the cut length
For a minimum length of the cut it is possible to use the trimmer without
a comb attachment. To completely remove the comb attachment, gently push
the attachment from the back of the device with your thumb until it releases
from the lock. To adjust the cutting length on the attachment, turn the wheel
(No. 6) clockwise or counterclockwise relative to the mark on the trimmer
body. Each setting level, see column "A", corresponds to a specific cutting
length in mm, see column "B" in the table Setting the lengths of the cut.
Beard trimming
Make sure that the beard is clean and dry before cutting it. Do not use
shaving gel or foam as they may damage the trimmer.
Trim your beard in the direction of the beard growth. Make sure the head is at
a right angle to the skin.
NOTE: Always turn off the trimmer during breaks in cutting.

CLEANING AND MAINTENANCE

You can remove the head with the blades. Press the head release button in
the direction of the arrow on the button and carefully remove the blades. The
shaving blades are sharp, so take extra care when handling them. When re-
inserting the cutting blades make sure that the head is properly seated in the
device. It has to snap into the body.
Turn off the device.
with water. Before reassembly, allow it to dry thoroughly.
cleaning brush to clean the cutting head with the blades.
blade head with water or any other liquid.
the moving teeth of the cutting edges with silicone oil after each use.
can use the supplied oil.
oils, fats or oils with solvents for lubrication. The solvents evaporate, leaving
a thick layer of lubricant, which can slow down the movement of the blades.
Gently press the blades from the underside to open the head and lubricate

the moving parts of the mechanism.
lint-free cloth.
10
The length of the cut may vary according

Start with the comb attachment set to the longest cut,

Remove the removable comb attachment and rinse

Use only acid free oil.

Before cutting for the first

We recommend gently lubricating

DO NOT USE vegetable

Remove excess lubricant with a dry,

English
Switch on the

Use the included

Never clean the

You
