HP CHPTOH-0711 Manuel De L'utilisateur page 130

Viewing questions
Symptom
I get a poor picture with video signal
input.
There is no picture, and I have an
external device controlling the TV.
The picture from a component-
connected input source is too red,
blue, or green, or it has black that is
too black or washed out.
I press Media, but nothing happens.
Remedy
Check the following: improper control setting, local interference, cable
interconnections. Adjust the picture control as needed. Try another
location for the TV. Make sure that all connections are secure.
Press the Source button on the remote control, and confirm the source
is selected.
Verify that the external device or PC power is turned on.
Make sure the source device is connected.
Check the power management function of the source device. Is it in
standby mode?
Connect the source to the TV. Operate the external device or PC
(move the mouse or press a key).
Make sure each cable is plugged into the correct color-coded
connector on the TV and on the input source device.
Make sure the cables are fully inserted at both ends.
See "Adjusting the picture image" on page 69.
Is HP MediaSmart TV the selected device on the remote control?
117
Troubleshooting