Appendix; Disassembly - LG WKEX200H A Série Manuel D'installation

APPENDIX

Disassembly

Disassembling the Washer and
Dryer
The washer and dryer cannot be disassembled and
installed for use side by side. If it is necessary to
disassemble the appliance in order to move or
reinstall it, follow these instructions.
WARNING
• Protect your hands and arms from sharp edges.
To reduce the risk of injury to persons, adhere to
all industry recommended safety procedures
including the use of long-sleeved gloves and
safety glasses.
1
Be sure to unplug the appliance.
2
Loosen screws assembled on the stack
bracket on the back of the appliance.
3
Push open the caps at the left and right sides
of the control panel on the front of the
appliance. Loosen the screws under the caps.
4
Pull the control panel forward to remove it.
5
Disconnect the wire harnesses from the
a
washer and dryer
CAUTION
• Always ground yourself before touching the PCB
or wiring. Discharge of static electricity may
cause product malfunction.
NOTE
• Tuck the wire harnesses to the side to avoid
pinching them.
6
Unscrew the second screw from the top of the
four screws on the left and right.
7
Lift the dryer and separate it from the washer.
APPENDIX 27
b
to the control panel.