Publicité
Les langues disponibles
Les langues disponibles
KMDL-01
Pen-type Digital Multimeter
•Turn power off and disconnect the test leads from the meter.
•Open the rear battery cover by removing one screw using a
screwdriver.
•Insert the battery into battery holder, observing the correct
polarity.
•Put the battery cover back in place. Secure with the screws.
Warning: To avoid electric shock, do not operate the meter until
the battery cover is in place and fastened securely.
Note: If your meter does not work properly, check the fuses and
batteries to replace.
Replacing the fuses
Warning: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the meter cover.
make sure that they are still good and that they are properly
inserted.
•Gently remove the old fuse and install the new fuse into the
holder.
•Always use a fuse of the proper size and value (0.5A/250V fast
blow for the 400mA range .
•Replace and secure the rear cover, battery and battery cover.
Warning: To avoid electric shock, do not operate your meter until
the fuse cover is in place and fastened securely.
8
www.grupotemper.com
Publicité
