Kübler CODIX 564 Série Guide Rapide page 33

for 100 mV
Select lower measuring range
limit
Input range
-105.00 ... +105.00 mV
Select upper measuring range
limit
Input range
-105.00 ... +105.00 mV
Select decimal point
(optical function only)
0
0.0
0.00
0.000
0.0000
0.00000
Select input low value
Input range
-105.00 ... +105.00 mV
Select display low value for
INP.LO.
Input range
-199999 ... +999999 and DP
Select input high value
Input range
-105.00 ... +105.00 mV
Select display high value for
INP.HI.
Input range
-199999 ... +999999 and DP
for TC.x
Select Temperature unit
Temperature in °C
Temperature in °F
Select cold (reference) junction
compensation
Internal compensation
External compensation
Select external junction
temperature
Input range
-99.9 ... +99.9°C or
-147.8 ... +212.0°F
Select Correction Value
(Offset)
Input range -99.9 ... +99.9°C
Input range -99,9 ... +99,9°F
Select resolution
0 °C/°F
0.0 °C/°F (not with TC.B, R, S)
all
Select Input Filter
The Filter function shows how
many measurement cycles are
used to determine the moving
average.
Input range 1 ... 99 [cycles]
- with a value of 1 the filter
function is switched off
Select Start Delay after Power
On
(limit monitoring is processed
only after the programmed
time has expired)
Input range 0.0 ... 99.9 [sec]
Select local mains frequency
Mains frequency 50 Hz
Mains frequency 60 Hz
The functions LO.LIM and HI.LIM limit the
editable range.
The value for HI.LIM must always be
greater than the value for LO.LIM.
Page 11