Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS (CONTINUED)
Shutting Down
1.
After each use, if you have applied chemicals, place detergent siphon hose into
container of clean water and draw clean water through chemical injection system to rinse system
thoroughly.
2.
Turn engine off. See Engine Owner's Manual.
3.
Turn water source off.
4.
Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
NOTE: Failure to release system pressure will prevent removal of high pressure hose from spray gun or
pump connection.
5.
See Storage section in this manual for proper storage procedures.
Risk of injury from spray. Always engage the trigger lock (O) when gun is
not in use. Failure to do so could cause accidental spraying.
Risk of property damage. Failure to do so could cause damage to the pump.
Risk of property damage. NEVER turn the water off with the engine running.
14
O
Figure 21
Publicité
Table des Matières
Dépannage
