Philips Perfect replacement SRP 5002/10 Mode D'emploi page 5

SRP5002_MA190508_v6.qxd:125254c4_SRU5110_86
Press and hold the OK key and digit key 1 until the LEDs under the
2
TV Mode key flashes twice
• If the LED of the TV Mode key flashes twice just once for an extended
period, the code has not been entered properly. Start again by pressing
the OK key and the digit key.
Check if you can operate all the functions on your TV with the SRP5002.
3
• If there are keys that do not respond properly go back to step 2 and
press OK key and digit key 2.You can repeat this operation until you find
the programming that better fits your Philips TV, combining the OK key
with any digit key from 1 to 9.
• For DVD you can combine the OK key with digit keys from 1 to 7
Tips for DVD set up:
If you own a Philips DVD rewritable without Hard Disk Drive, while
setting the remote control, on chapter '2.3 Setting the remote control',
step 2, press OK key and digit key 3.
If you own a hard drive Philips DVD recorder, while setting the remote
control, on chapter '2.3 Setting the remote control', step 2, press OK key
and digit key 4.
If you own a Philips Blu Ray DVDplayer, while setting the remote control,
on chapter '2.3 Setting the remote control', step 2, press OK key and
digit key 6.
You might also find your set up code for Philips DVDR with Hard Drive
by model. On the chapter 'DVD setup by model' you can look for your
Philips DVD model and its set up code.
When setting up the remote for DVD, be sure to press the DVD mode
key before starting the set up from step 2.
Installing the remote control
19/05/08
4
18:33 Página5
4
5