Storing The Pressure Washer; Pump Maintenance - Milwaukee 4555-22 Manuel D'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STORING THE PRESSURE WASHER

See Figures 21 - 22.
It is important to store this product in an area that will
not experience freezing temperatures. Always empty
water from hoses and pump, and empty fuel from the
fuel tank.
NOTE: Use of a fuel stabilizer and pump saver will give
you better performance and increase the life of the
machine.
AFTER THE MACHINE HAS COOLED COMPLETELY:
Discharge Fuel:
Drain the fuel tank completely. Stored gas can go stale
in 30 days.
Engine Oil:
Drain the oil and replace with fresh, clean oil.
Spark Plug:
1. Disconnect spark plug wire and remove the spark plug.
Pour about a teaspoon of clean, air-cooled, four-cycle
oil through the spark plug hole into the combustion
chamber.
2. Leaving the spark plug out, pull the starter cord two
or three times to coat the inside of the cylinder wall.
3. Inspect the spark plug and clean or replace, as neces-
sary.
4. Reinstall the spark plug, but leave the spark plug wire
disconnected.
Air Filter:
1. Clean or replace the air filter according to engine
manufacturer instructions. (See engine manual.)
Hoses and Pump:
Flush the injection hose with clean water for 1-2 minutes.
Remove all hoses. Empty the pump by pulling on the
recoil starter about 6 times. This should remove most of
the liquid from the pump.
Moving Handle:
To collapse the moving handle for storage, pull and hold
the release pin while pushing the handle down.
PREPARING FOR USE AFTER STORAGE
1. Pull the recoil starter grip three or four times to clean
oil from the combustion chamber.
2. Remove spark plug from the cylinder. Wipe oil from
the spark plug and return it to the cylinder.
3. Reconnect the spark plug wire.
4. Refuel the machine as described earlier in the opera-
tor's manual.
MAINTENANCE

PUMP MAINTENANCE

We recommend having the pump oil changed every 200
hours to ensure longer life of the machine. This service
should be performed by an authorized service center.
Fig. 21
RELEASE
PIN
Fig. 22
TO STORE THE MACHINE
page 19

Publicité

Table des Matières
loading

Table des Matières